top of page
Drawing 17.png

Sample & Hold


The Hungry Robot Sample & Hold provides basic S&H functionality with some added bells and whistles. It uses an internal clock dialed into a very useful range. If the internal clock rate is not to your liking, you can bypass the Rate knob by patching a clock signal into Clk In. The Sample & Hold has a built in attenuverter giving a bit of added control over the random voltages that are outputted. White noise out for uses elsewhere. Traditionally a S&H samples voltages from chaotic white noise, but E.In allows you to bypass the white noise and patch in your own sample source (i.e. patching an LFO in for a bit crushed LFO). As with all Hungry Robot "Modular Boxes" the Sample & Hold can be powered with a simple 9V DC, Negative Center power supply.



-MINUS/PLUS: Attenuverter for output. Allows you to sweep between positive and negative voltage outputs.

-RATE: On board clock source ranging from approximately 25ms to 1000ms.



-E.IN: Bypasses internal white noise as a sample source. Patch in any CV source that you want to sample from

-STATIC: Taps into white noise output (0-5V range)

-CLK IN: Bypasses internal clock with your provided external clock

-S&H OUT: Two buffered outputs of S&H voltage


Dimensions: 4.7” x 2.6”

Power (Through Hole Units): 9V DC - Negative Center - 2.1mm Barrel

Power (Surface Mount Units): 9V-12 DC - Negative Center - 2.1mm Barrel


Hungry Robot
Hungry Robot
bottom of page